Ne isplati se za klimu. Ja sam se to zanosio da radim na Bori pre nego sto sam je prodao. Kostalo bi me sa polovnim delovima oko 600e, nisam siguran s tim sto si video koji kupus nastaje kad se sve razbuca. Ovde imas detaljno:
http://forums.vwvortex.com/zerothread?id=413346Od delova treba otprilike ovo:
Given that you already have the HU (which hopefully works) It may not be that hard to do this mod.
I have never tried doing this nor have I taken apart the manual one. But I have taken apart my climatronic and can probably identify most of the components. If all you have is the HU then to give you an idea, here are the things that you will need (plus I'm sure a few more.)
1. You will need I think 4 wire harnesses and figure out all the places they are going to connect.
2. There is an outlet air sensors in the footwell outlets. Cant remember if there was one in center console as well or not.
3. A sunlight photo sensor on the dash.
4. Fresh air temperature sensor in the fresh air duct behind the filter.
5. Ambient air temperature sensor in the front bumper (and to answer your question, no the ambient air temperature doesn't hinder the operation of the Climatronic. I'm not sure if the Climatronic will fire up an error code if the sensor is missing. You may have to put a static resistor in its place if you don't want to install that sensor. Though installing the ambient air temp sensor is the easiest of all to install.
6. Center airduct flap motor and position sensor (which is actually part of the motor module itself.)
7. Defroster / footwell outlet flap motor module.
8. Temp control flap motor module
9. Air flow flap motor module.
10. and the Blower motor amp/control module.
The electrical connections will probably be the hardest to figure out. Other stuff is just taking apart the dash and putting the sensors and motors in place.
Ako te svrbe pare, mogu ti dati i tel. dobrog majstora koji to moze da odradi....
